Posted By:   TeamDino5280
Post Date:   10/15/2012
Category:   Ski/Board Gear

 Burton Splitboard package

This is a DIY Split that I did as a project last season. I have since switched back to AT. This is a full set up: Board, Hardware, Skins, Plate hard boot bindings and regular bindings. This package would be great for someone wanting to get into splitboarding. Skins and the hardware package alone cost over $350


-REGULAR FOOT ONLY (Cannot be ridden goofy)
-Burton Jussi Oksanen Pro model
-157.5 cm (I wanted a short board for steeper terrain)
-Full wood Core
-Bindings are set further to the tail for more float to compensate for the shorter length in powder.
-Bindings are both angled forward for more drive (not for riding switch)
-Volie hardware (plates, touring brackets, tail and nose clips)
-Karakoram latch system (draws the board together much tighter than the Volie latch.

-Voile Tractor Skins
-Volie hard boot plate bindings
-Burton Custom bindings (standard snowboard bindings) these are an older pair

Please email or PM any questions


PM or EMAIL wjohnsmiller84(at)gmail
My Forum Profile (PM and Email Links)

 Comments or Questions

   Using your forum id/password. Not registered? Click Here

© 2017®, 14ers Inc.