## Horizontal Distance vs Hypotenuse Distance

Items that do not fit the categories above.
Forum rules
This forum is for general, mountaineering-related topics. For more details, please see the Terms of Use you agreed to when joining the forum.
TravelingMatt
Posts: 1919
Joined: 6/29/2005
14er Checklist (56)
13er Checklist (355)

### Re: Horizontal Distance vs Hypotenuse Distance

No map will show every curve in a trail, nor will GPS account for every curve, as mentioned above.

I estimate distances by some consensus of ascent time (~2.3 mph on easy Class 1), descent time (~3 mph on easy 1) and map distance + fudge factor. Naturally my ascent and descent times depend on terrain, my physical condition that day, rest stops, pack weight and so on. I spend a lot of my downhill time deciding whether I'm going 2.7 mph or 2.8. I need to get out more. Or is that less?
AC 0000000
pseudoghost
Posts: 106
Joined: 8/15/2010
14er Checklist (32)
13er Checklist (2)

### Re: Horizontal Distance vs Hypotenuse Distance

Honestly, unmarked switchbacks and other trail variations add up to more than the difference between the horizontal distance and the hypotenuse distance. This is even true for relatively short trails, like Bierstadt.
lodidodi
Posts: 677
Joined: 12/26/2006
14er Checklist (26)
13er Checklist (1)

### Re: Horizontal Distance vs Hypotenuse Distance

tlongpine wrote:"Everyone uses distance and elevation gain for their hikes but I'm assuming everybody uses horizontal distances from a map."

Why are you making that assumption?

Surveying uses horizontal distance to make maps and I've been trying to find out if GPS calculates the actual "slope" (hypotenuse, ground, surface, or true) distance or if a gps calculates horizontal distance as well. I think GPS's calculate horizontal distance because the system is based on UTM coordinates and then it basically takes the difference between the two readings of coordinates and calculates your distance. I don't know if it adds in the elevation change. If you step off a 5,000 foot building is it going to show you traveled 1 foot in distance or 5,000 ft? I found an article by Conoco about pipe lengths and it took them 2 years to develop a software to put gps data into to calculate actual pipe lengths. I don't know if Garmin (or any other brands) has built this formula into their gps's. If a surveyor uses a total station, it will give a reading for slope distance and horizontal distance. Maybe a surveyor or somebody in this field can clear this up for me?
Dancesatmoonrise
Posts: 2142
Joined: 9/25/2009
14er Checklist (58)
14ers in Winter (43)

### Re: Horizontal Distance vs Hypotenuse Distance

.
Last edited by Dancesatmoonrise on Thu Dec 06, 2012 5:10 pm, edited 1 time in total.
jdorje
Posts: 1485
Joined: 6/16/2010
14er Checklist (11)
13er Checklist (22)

### Re: Horizontal Distance vs Hypotenuse Distance

lodidodi wrote:Surveying uses horizontal distance to make maps and I've been trying to find out if GPS calculates the actual "slope" (hypotenuse, ground, surface, or true) distance or if a gps calculates horizontal distance as well.

Any competent GPS software should use straight-line distance between two points (what people are calling the hypotenuse). This requires very simple math from the ECEF coordinates which are what GPS hardware outputs.

That said, I have no idea. The android GPS interface does not give programmers the ECEF data (which is easy to calculate from the lat/lon/alt), but does provide a complicated function to determine the earth-surface distance between two points. In short, it's intended for 2d use, and writing an android app to show the straight-line distance takes considerably more work than writing one to show the earth-surface distance.

Most trail distances that are accurately measured are probably done so by running a wheel along the trail and counting the revolutions. At least, that's how I would do it; bicycles can do this automatically of course. Done correctly, this would give a very accurate distance.
-Jason Dorje Short
Jim Davies
Posts: 7872
Joined: 6/8/2006
14er Checklist (58)
14ers in Winter (1)
13er Checklist (61)

### Re: Horizontal Distance vs Hypotenuse Distance

Since the error in GPS altitude measurement is so high, including that in the point-to-point distance calculations could throw them off quite a bit.
Climbing at altitude is like hitting your head against a brick wall — it's great when you stop. -- Chris Darwin
jdorje
Posts: 1485
Joined: 6/16/2010
14er Checklist (11)
13er Checklist (22)

### Re: Horizontal Distance vs Hypotenuse Distance

Jim Davies wrote:Since the error in GPS altitude measurement is so high, including that in the point-to-point distance calculations could throw them off quite a bit.

Indeed. Significant smoothing would be required.
-Jason Dorje Short
Rarefied
Posts: 183
Joined: 9/29/2010
14er Checklist Not Entered

### Re: Horizontal Distance vs Hypotenuse Distance

lodidodi wrote:If you step off a 5,000 foot building is [the GPS] going to show you traveled 1 foot in distance or 5,000 ft?

A version of that scenario can be developed in MapSource. First, perform an overzoom (80' setting) on the Independence Monument outside Grand Junction. Using the distance tool, start at the 5700' contour at/near the summit and proceed southeast to the nearby 5400' contour for a vertical drop of 300'. (Make your distance line perpendicular to that contour.) Yet, the distance tool will show a value of 75-80' depending upon how you draw that line -- that's the horizontal distance. (By the way, at 300' & 80' that's a 75 degree slope -- and it looks it!)

To state it another way, your GPS would show (assumes adequate resolution) you had traveled 80' whether you rappelled down to 5400' or flew a hang-glider off the summit and maintained 5700' until you were precisely over the same spot. (For a larger scale version, proceed due south from Quandary's summit to the north shore of the larger of the Blue Lakes and compare the numbers that way. Or for that matter, any number of other locations in the state will also work.)

R